Calibration Techniques for Water Content Measurements in Solid Biofuels

This paper presents methodologies and equipment for SI-traceable inline measurements of water content (a critical quality parameter) in solid biofuels. Inline measurement systems for water content are commonly used at CHP plants, providing continuous real-time data. However, the accuracy of these systems is in most cases unsatisfactory, mainly because the systems are not calibrated representatively for the relevant material, and until now, calibrations traceable to the SI system have not been available. To provide reliable and accurate inline water content data, new procedures and equipment for calibrating measurement systems were developed. Two reference methods for the determination of water content were developed; one measures the airflow and dewpoint of desorbed water in the air passing a test sample, while the other uses a P2O5-sensor. Additionally, a transfer standard based on a cavity resonance sensor was developed for fast onsite calibration of the inline sensor at the power plant. This new instrument allows for quick and accurate measurements. The transfer standard is made metrologically traceable to the primary measurement standards. The entire system was demonstrated by calibrating an inline microwave-based (MW) sensor at the CHP plant of VERDO in Randers, Denmark. Thus, a complete metrological traceability chain was established from an industrial to a primary standard.